Not sure how the integrated fusion tab works, but i'm guessing it is a similar workflow.perhaps using proxys from Resolve? so if your Resolve timeline is set to HD when you send the clip to Fusion, i would guess you are using an HD clip inside Fusion. Again, assuming your sources are at 4k in the first place. When it is time to render, switch your timeline back to 4k, check your image resize settings are correct, and then you can render out a 4k image with no quality loss. (which is less taxing on the system than a 4k timeline). You are now working with 4k media from fusion, in an hd timeline. Render your fusion clips, then in Resolve, jump back to HD to complete your work. The proper way (in standalone fusion) is to set your resolve timeline to 4k, create your fusion media.then you have 4k sources through out the path. Simply rendering your timeline to 4k at the delivery page is not the way to go, unless you have set your timeline to 4k, and your sources are 4k, otherwise you are simply blowing up the image, and yes some pixilization will occur. Inside fusion you can certainly change the size of your comps, just be sure you are using the original 4k sources for this. I'm making a guess, as I use standalone fusion.i don't use the integrated fusion at all.but in my typical workflow, which involves Resolve exporting new media into fusion:Īssuming your source footage is 4k and your resolve timeline is HD, when you create your fusion clip, it creates it at the resolve resolution. If checked here, you can change the size of the image keeping the aspect ratio of the canvas.I think your problem is that you created your fusion node while at HD. When unchecked When the dpi value is changed, the value of (px) unit does not change, the value of (cm) and (inch) unit changes. To “Fixed print size” When checked When the dpi value is changed, the value of (px) unit changes and the value of (cm) and (inch) unit does not change. If “Comic guide” is displayed, set the image size to “Comic guide”. When “Apply” is pressed in the state of this figure, the value of area (A) becomes 200% (doubled). Press the “Apply” button to apply the pull down value to the numerical value of (A) area. If you want to change the width and height separately, please uncheck “Constrain Proportions”. I usually see bonding bushings specd for rigid take-offs. 392.6 (A) Trying to understand about the conduit. When “Constrain Proportions” in (E) is checked, the ratio of width and height is fixed. Your bonding jumpers are sized from 250.102 and used only when you have mechanically discontinuous segments (usually limited to 6 feet). By pressing the “(px)” “(cm)” “(inch)” button at the top, you can switch the unit to be edited.
You can directly specify the size of the image. To change the resolution, use “Edit” -> “Image Size” in the menu. It is also possible to change only the dpi value without changing the size of the picture at all. Changing the resolution allows you to enlarge or reduce the entire picture on the canvas.
0 kommentar(er)
